Brewery Upgrades
Moderator: slothrob
5 posts
• Page 1 of 1
Brewery Upgrades
Finally weary of hefting kettles of near boiling liquid around I bought a pump... But that's no good without a sweet stand, right?
Pictures at:
http://www.essersnet.com/brew03t/Thumbs1.htm
Note, it is not yet plumbed nor is the pump installed.
Cheers!
Charlie
Pictures at:
http://www.essersnet.com/brew03t/Thumbs1.htm
Note, it is not yet plumbed nor is the pump installed.
Cheers!
Charlie
-
Push Eject - Double IPA
- Posts: 233
- Joined: Wed Mar 21, 2001 2:01 pm
- Location: Lancaster, CA, US
Cool Stand
Looks great!
If I get the SS fermentor from my friend, I'll need to do something like that too.
If I get the SS fermentor from my friend, I'll need to do something like that too.
- fitz
- Strong Ale
- Posts: 442
- Joined: Thu Dec 19, 2002 9:36 am
Rock on
I was amazed how little steel costs. The angle iron was $28, the expanded sheet was about the $26. The CASTERS cost more than that!
Charlie
Charlie
-
Push Eject - Double IPA
- Posts: 233
- Joined: Wed Mar 21, 2001 2:01 pm
- Location: Lancaster, CA, US
I noticed
I noticed you put a set of good casters on it.
Most people would try to go cheap there, and then cuss the stand for not moving well. Good choice. I have some stainless, that I wasn't sure what to do with, but it was stainless, so I wasn't going to throw it out. I now have a use for it.
Most people would try to go cheap there, and then cuss the stand for not moving well. Good choice. I have some stainless, that I wasn't sure what to do with, but it was stainless, so I wasn't going to throw it out. I now have a use for it.
- fitz
- Strong Ale
- Posts: 442
- Joined: Thu Dec 19, 2002 9:36 am
Dimensions
Could you post or send to me? I need to build this ASAP!!!
- Madbrew
- Posts: 7
- Joined: Fri Mar 14, 2003 9:54 am
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests