New to the game

Brewing processes and methods. How to brew using extract, partial or all-grain. Tips and tricks.

Moderator: slothrob

Post Reply
Posts: 2
Joined: Fri Dec 26, 2003 4:53 pm

New to the game

Post by AUTigerbrew » Fri Jan 16, 2004 9:38 pm

Hey everyone,
I am brand new to all of this having just recieved by brewing equipment as a Christmas gift. I have already jumped in and started my first batch which is ann Imperial Stout that was just a beer kit recipe. I will be bottling next week. My real question is where do I go from here. I would love to hear some advice about what might be a good brew to try next. I would like to try a lighter beer next. Ideally, I want to try my hand at Munich Helles or a Pilsner Urquell. What would be your advice for my next brew (keeping in mind that I am very new and not familiar with many brewing techniques just yet. Thanks


Imperial Stout
Imperial Stout
Posts: 561
Joined: Sun Dec 31, 2000 11:37 am
Location: Ohio


Post by BillyBock » Sat Jan 17, 2004 1:29 am

Welcome to the clan! Nothing like pouring a friend a beer and him asking "You made this?"

As far as what to brew? Hmmm...I'd suggest a Pale Ale or an India Pale Ale--in my opinion you just can't go wrong with one of these. The Munich Helles and Pilsner are lager beers. In order to pull these off successfully, it will require some gear and techniques that you may not have just yet.

Spend time focusing on your procedures, especially your sanitation. It's a tearful event when you lose a batch because you were sloppy with sanitation. Get the hang of the basics and then move on up. Spend time looking through various books and ask your questions here. John Palmer has a good online book here Incidentally, what kind of brewing kit did you get?

Oh and the other starting tip I'd give you is to not use straight tap water. It contains chlorine (some places use chloramine) to keep nasties down in the pipes. However, chlorine reacts in the boil and creates medicinal flavors. Yuk..So unless you want to make a Vicks 44 brew you might want to use bottled water or charcoal filtered water.

And where do you go from here? Let your tastebuds be your guide, Grasshopper :-)


Pale Ale
Pale Ale
Posts: 50
Joined: Mon Jul 31, 2000 5:09 am
Location: Wollongong Australia

Where are you from

Post by Raydownunder » Sat Jan 17, 2004 4:16 am

Hi Tiger

Sounds like an old story, Here are you from as the start of your name is AU. Are you from Australia.

Posts: 2
Joined: Fri Dec 26, 2003 4:53 pm


Post by AUTigerbrew » Sat Jan 17, 2004 8:49 am

Thanks for the advice. By the way I am from Birmingham, AL. The AU in my name is for Auburn Tigers, that's where I went to school.


Light Lager
Light Lager
Posts: 19
Joined: Sat Dec 28, 2002 10:47 am
Location: Dousman, WI, US

Go Slow

Post by Bowhunter » Sat Jan 17, 2004 1:50 pm

As Billybock said, GO SLOW, There is no need to rush. Yes water is very important. My home is provided with city water, so I went and cut a 2 1/2 inch hole in my basement floor and drove a sandpoint down about 20 ft. The basement floor is about 10 ft.below outside ground surface so I,m really down 30 ft. with the sandpoint. I attached a well pump and pressure tank and walla I have clean mineral water piped to my brew sink. The cost for material was about $325.00 but I don't worry about nasties from city water.


Pale Ale
Pale Ale
Posts: 55
Joined: Sun Dec 29, 2002 9:40 pm

read read read

Post by canman » Sat Jan 17, 2004 2:29 pm

Welcome to the hole in which you shall pour money.
Read everything beer related, I second it is excellent.
Work on technique first, boil as much of the wort as you can, you can taste the difference. If you have city water but can't afford bottled or filter system, pour water 2 days before and let sit covered.
I would also say a pale ale, heed temperature warnings for fermenting. You want to ferment cool not warm like everyone new seems to think.

Double IPA
Double IPA
Posts: 170
Joined: Fri Sep 07, 2001 1:56 am

Here is another couple of suggestions.

Post by Brewer2001 » Tue Jan 20, 2004 4:19 am


All of the information that the guys gave you is correct. Two other things that will help you along faster are detailed notes and replication.

A detailed log book with each brewing recipe and session will be very helpful as a reference, make good notes and review them often.

The second thing is to brew, as Bill stated, a middle of the road beer (ale). Make a style that you like (buy a sample if you don't have a good taste profile in your mind) than try to brew it repeatedly until it comes out the same every time (this is very important should you go to all grain brewing). You should be able to detect any differences and change your brew 'at will'. When you can do this, you will begin to understand what the brewing texts are trying to tell you. I would start with a lighter less hopped ale, the Stouts and IPA's tend to mask imperfections. You are trying to train your pallet and discover new things not hide them. Follow all the advise given here and you will make good beer!

I am a semi-pro brewer and I follow all the basics and I read some part of a brewing text every day. Keep reading........

Good brewing,

Tom F.

Post Reply