Page 1 of 1

Manually input mash tun capacity volume

Posted: Sat Apr 11, 2015 12:12 pm
by cheetrowe
Just ran into this...my mash tun is a wheeled cooler, which means that the height, width, and length dimensions do not give an accurate capacity volume. It would be helpful if the software let you manually introduce the volume capacity (for now I had to fiddle with the measurements so that they produced the correct volume of the cooler).

Re: Manually input mash tun capacity volume

Posted: Sun Apr 12, 2015 9:53 am
by slothrob
If you enter the Width and Length of the tun opening or floor, then the Volume, BeerTools Pro will calculate a Height that fits the three measurements.