Temperature descrepancy in mash schedule

General discussion on BeerTools Pro Software.

Re: old thread but I have a question

Postby jeff » Fri Aug 28, 2009 7:19 pm

conman wrote:but I adjusted the Heat Capacity down to 0 degrees and now the temps are the same. what is the program figuring with the heat capacity?

Heat capacity affects the quantity of heat BTP assumes will be lost to the vessel when the hot water is added. If you want the numbers to line up, you should make sure the heat capacity of the mash tun is the same in both the strike temp calculator and the mash-in step for the schedule. Hope that helps.
BeerTools.com Staff
User avatar
Imperial Stout
Imperial Stout
Posts: 1492
Joined: Sun Jan 09, 2000 9:16 pm
Location: Hollywood, SC


Return to BeerTools Pro General Topics

Who is online

Users browsing this forum: No registered users and 2 guests