Analysis feature

General discussion on BeerTools Pro Software.

Analysis feature

Postby brocktonbrew » Fri Apr 25, 2008 5:10 pm

Question about the analysis feature in BeerTools Pro. I am having a problem getting the "WATER" in the session analysis feature to read anything other than 0.0 gallons. I have loaded a water profile and put in the correct volume of water on that page, as well as on the main session page, but the analysis section keeps showing 0.0...any suggestions?
Posts: 3
Joined: Fri Apr 25, 2008 4:50 pm

Postby ColoradoBrewer » Sat Apr 26, 2008 9:57 am

Have you set up a mash schedule? The volume of water under the Analysis tab is taken from that, I believe. Go to the drop down list (under the beer glass) and click on Session to set up a mash schedule. You should see the amount water needed under the Analysis tab.
BTP 2.0.18 (Windows 10 64 bit)
User avatar
Strong Ale
Strong Ale
Posts: 275
Joined: Tue Oct 24, 2006 11:32 am
Location: South of Denver, North of the Springs

Return to BeerTools Pro General Topics

Who is online

Users browsing this forum: No registered users and 2 guests