Mash Tun Calibration - Infusion Temp

General discussion on BeerTools Pro Software.

Mash Tun Calibration - Infusion Temp

Postby camelfilter » Sun Aug 12, 2007 4:21 pm

Stupid question, but just double-checking. I'm calibrating a new mash-tun I've created (50qt Coleman w/SS braided hose manifold) and questioned myself on the infusion temp setting. Is this asking for the water temp PRIOR to actually dumping it into the mash-tun (which I think is right), or is it the temp of the water immediately AFTER I've dumped the water in. I know if sounds silly, but I just wanted to double-check. Let me know.

Light Lager
Light Lager
Posts: 25
Joined: Mon Jun 25, 2007 4:37 pm

Postby ColoradoBrewer » Sun Aug 12, 2007 6:07 pm

Yes, it is the temp the water is heated to prior to dumping it in. Think of it as the equivalent to the strike temp if you were doing an actual mash.
User avatar
Strong Ale
Strong Ale
Posts: 277
Joined: Tue Oct 24, 2006 11:32 am
Location: Fremont County, CO

Postby rrosa » Mon Aug 13, 2007 4:54 pm

I mash in a different way. I use a pot as a mash-tun, heat the water with it and then dump the grist. The major difference is that the mash-tun is heated. I am not sure how to calibrate the vessel this way; it is certainly not as suggested in BTP (to dump the hot water into the vessel which is at room temp). Maybe I should just heat the vessel with water to the specified temperature, turn off the heat, and then measure the temperature again. Does that sound right?
Ricardo -
MacBook 2GHz Intel Core 2 Duo 2Gb SDRAM running Mac OS X Snow Leopard 10.6.8
User avatar
Pale Ale
Pale Ale
Posts: 55
Joined: Mon Jan 15, 2007 9:32 pm
Location: Rio de Janeiro

Postby kieran » Sun Apr 17, 2011 2:31 am

Sorry for reviving a very old thread.

I'm doing the same thing right now.
1. I've just calibrated a kettle (not as a heat source). Approx 47C water went to 42C when I put it in.. but this doesn't really matter, as I use immersion elements to heat water in here. So I heated my water (taking temperature measurements along the way to calibrate my heat source).. then stopped at 75C, and removed all heat sources, and calibrated from there. I used 18L of water to do this (just a hair under 5 gallons).

My mash tun is next..
I know it will drop about 5C from the time it leaves my kettle (which I use to heat all my water) to the time it gets into the mash tun/esky. I always account for this anyway.. So do I Use the last temp as it was in the kettle as my INFUSION TEMP. as T=0.. and wear all the temperature drop during the transfer, and the cooling effect when it hits the mash tun.. with t=5min being significantly lower than it would for a pre-warmed mash tun?? Or do I treat it as pre-warmed, once it is in the Esky as T=0.. ? The numbers will be VERY different!!

It would be easier if there was a T=0 being in the kettle.. t=5min for a transfer/vessel heating shift, then t=10min for a short-term thermal mass loss.. or something. then a t=65 for whatever else.

Or am I missing something completely here?

Please please help!
Light Lager
Light Lager
Posts: 30
Joined: Thu Nov 02, 2006 7:46 pm
Location: Melbourne

Return to BeerTools Pro General Topics

Who is online

Users browsing this forum: No registered users and 3 guests