First-time cleaning of brass and copper

Physics, chemistry and biology of brewing. The causes and the effects.

Moderator: slothrob

First-time cleaning of brass and copper

Postby kabbo » Fri Apr 14, 2006 6:56 pm

Hello, I have built a copper manifold with soft copper tubing and brass compression fittings. Everything is already assembled so the brass sleeves are held permantly on the copper pieces so are the brass nuts.

I read on John Palmer's
kabbo
Pale Ale
Pale Ale
 
Posts: 50
Joined: Sat Mar 11, 2006 1:46 pm

Postby BillyBock » Sat Apr 15, 2006 12:51 pm

I'm not sure what it'd do to the copper. You could take a scrap piece of copper and put it in the pickling solution to see what happens.

I suspect your sleeves and brass nuts are at the end of the pipe? I'd try and just suspend the device so only the brass and very little copper is submerged in the pickling solution.
BillyBock
Moderator
Moderator
 
Posts: 561
Joined: Sun Dec 31, 2000 12:37 pm
Location: Ohio


Return to Brewing Science

Who is online

Users browsing this forum: No registered users and 0 guests