Heat source calibration

[ASYMetric]

Hello, I have been using beertools for some time now with great results, but recently began to calibrate my equipment.

My question is: In the Heat Source Editor, beside Vessel Heat Capacity there is a drop down arrow. Is that supposed to pick up my calibrated vessels to input the heat capacity for the vessel that I used to calibrate my heat source?

I realize I could copy and paste the info, but was wondering if maby I was doing something wrong to cause the software not to populate that list with my vessels.

[ASYMetric]

Figured it out. Once I had a recipe open and imported the vessels into the recipe, then created the Heat Source calibration, the dropdown was populated at that point. Not sure why it works that way, but problem solved.