I'm trying to set my mash schedual to do a combination of both Batch and Fly sparging. But I cant get my fly water value to equal the remainder needed to get to my pre boil levels after I have adding the two previous Batch sparges.
This is what I'm trying to do...
Mash-In - To Mash Tun
Mash-In Rest
Batch Sparge #1 - To Boil Kettle
1: Drain off liquor and rinse over mash four times. 1 gallon at a time
until clear.
2: Drain liquor off to the Boil Kettle.
3: Dont add sparge water.
Infusion - To Mash Tun (add water to mashtun)
Infusion Rest
Batch Sparge #2 - Same as Batch Sparge #1 (See above)
Fly Sparge - The remainder of the water needed to get to pre-boil level.
Can this be done?
HELP! Mash Schedual. Combo Batch & Fly.
Batch + Fly Sparge
I think that the software expects a sparge to be the end of the schedule, so it has a problem with trying to stack a fly sparge on top of a batch sparge.
I think you'll need to use a batch sparge edit box with 3 sparges. The third sparge step can be used to calculate the temperatures and volumes for your fly sparge and you can give it a name like "2 Batch + 1 Fly Sparge".
As a side note, is there a particular reason you are using such an extreme sparge? Usually a second sparge is already bumping up against diminishing returns. I think that adding a fly sparge to the end, after having removed almost all of the sugars during the batch sparges, would risk over-sparging and extracting tannins.
I think you'll need to use a batch sparge edit box with 3 sparges. The third sparge step can be used to calculate the temperatures and volumes for your fly sparge and you can give it a name like "2 Batch + 1 Fly Sparge".
As a side note, is there a particular reason you are using such an extreme sparge? Usually a second sparge is already bumping up against diminishing returns. I think that adding a fly sparge to the end, after having removed almost all of the sugars during the batch sparges, would risk over-sparging and extracting tannins.
BTP v2.0.* Windows XP