adjustments on a barley crusher malt mill??

[timbah]

anyone with suggestions on adjustments from the factory .39 setting it seems a little dusty for a crush (checked gap with feeler gauge so it is on .39)

[slothrob]

I actually went a little tighter.

A little flour shouldn't hurt your sparge. If it bothers you, you could try malt conditioning. If you spray about 100 mL/10# grain, you'll reduce the amount of flying dust and improve the quality of the husks. This is a good write-up of malt conditioning.

[jawbox]

I tightened up mine a little too. Had no problems with stuck mashes even with my Brutus in constant recirculation.
I'd leave the factory setting unless you're having problems

[timbah]

thanks a million for your input ! that is a excellent idea on malt conditioning

[jawbox]

I'd be concerned introducing moisture to a carbon steel roller, I don't like rust.

[timbah]

and another good point from jawbox.... thanks i did not think of that at first that is very true guess ill have to dry it out right after im done. first time using a mill