Analysis feature

General discussion on BeerTools Pro Software.
Post Reply
brocktonbrew
Posts: 3
Joined: Fri Apr 25, 2008 4:50 pm

Analysis feature

Post by brocktonbrew »

Question about the analysis feature in BeerTools Pro. I am having a problem getting the "WATER" in the session analysis feature to read anything other than 0.0 gallons. I have loaded a water profile and put in the correct volume of water on that page, as well as on the main session page, but the analysis section keeps showing 0.0...any suggestions?
User avatar
ColoradoBrewer
Strong Ale
Strong Ale
Posts: 287
Joined: Tue Oct 24, 2006 11:32 am
Location: Fremont County, CO

Post by ColoradoBrewer »

Have you set up a mash schedule? The volume of water under the Analysis tab is taken from that, I believe. Go to the drop down list (under the beer glass) and click on Session to set up a mash schedule. You should see the amount water needed under the Analysis tab.
BTP 2.0.22 (Linux (.deb) 64 bit)
BTP 2.0.24 (Windows 10-20H2)
BTP 2.1.0.9 Beta (Windows 10-20H2)
Post Reply