Every once in a while....
Moderator: slothrob
-
- Strong Ale
- Posts: 339
- Joined: Sat Mar 17, 2001 11:33 pm
- Location: Hummelstown, PA, US
Every once in a while....
Every now and then, I open a bottle of brew and there just isn't any fizz. I dont understand why I still have this problem. I put the appropriate amount of corn sugar in to prime, the bottles and caps are clean. So what the @#%$!!! Sorry about that. But ut us very upsetting when you spend all the time and effort to brew a good beer and this happens. I suppose I have to go back to adding a couple granules of yeast to every bottle when I am bottling. That still doesn't explain why though. Am I letting the beer sit to long and all of the yeast are dying??? I had this problem last year with a couple of batches. I just hate having to open all of them up again, just to add some little critters to each bottle. Oh well, just letting off some steam 'cuz I wanted to enjoy a cream ale tonight and I was thwarted. Later, Ed.
Are you.....
Putting the priming sugar/water solution in the bottom of the bottling bucket before you transfer the beer from the fermenter? I had that problem with a batch that I had forgotten the priming sugar and had to add it after the brew was already in the bottling bucket. I don't think the priming sugar dispersed(sp) evenly.
Also what do you sanitize with? Is it possible there was a bit left in a couple bottles and it killed the yeast? I don't know if this is really possible or not, but it was a thought I had.
Also what do you sanitize with? Is it possible there was a bit left in a couple bottles and it killed the yeast? I don't know if this is really possible or not, but it was a thought I had.
overfilling
Be sure not to overfill the bottles. There should be ~1 inch of space between the beer and the bottle top. Overfilling may cause undercarbonation. Likewise, under filling may cause overcarbonation.
-
- Pale Ale
- Posts: 68
- Joined: Sat Mar 02, 2002 11:49 am
- Location: Roscoe, IL, US
could be the caps?
This might be the last possible reason, but, sometimes when you bottle, if the caps are not totally snug, it seems like the seal isn't good enough to contain the pressure. I have had this problem before too.
Stir
You are boiling your priming sugar in water before adding it to the beer prior to bottling, right? I had a similar opportunity and now I stir the beer in the bottling bucket after adding the priming sugar solution. This resolved my problems. It seemed that the priming sugar was inconsistently dispersed in the beer prior to bottling. Just give it a stir with a non-porous, sanitized spoon just before you bottle.
Cheers,
Ford
Cheers,
Ford
-
- Light Lager
- Posts: 46
- Joined: Sat Mar 17, 2001 1:46 pm
- Location: Lincoln, NE, US
that's me in the corner, that me in the spotlight...
How long do you let your brew sit before you bottle? If you let your beer age in the secondary for over a month a good practice is to pitch some yeast along with the priming media. I do this often- my beers usually sit in the secondary for over a month. I have not had a problem with undercarbonation as long as I was sure to add more yeast with the priming method. The added yeast need not be expensive. I use a packet of dry- it will not alter the flavor, no matter what anyone would have you believe. The secondary fermentation is a much smaller scale. Prost!