Handling DME?

Grains, malts, hops, yeast, water and other ingredients used to brew. Recipe reviews and suggestions.

Moderator: slothrob

Handling DME?

Postby pipdav » Mon Apr 02, 2001 3:02 pm

Is there a way to use DME without having it clump
or stick to everything? I measure out the correct
amount for my recipe but I lose some of it to clumping
from the steam of my pot.
pipdav
 
Posts: 1
Joined: Mon Apr 02, 2001 6:43 pm
Location: Milwaukee, WI, US

To dme or not to dme...

Postby Push Eject » Wed Apr 04, 2001 6:35 am

Pipdav,
I've recently given up on dme in favor of liquid extract. I observed many incomplete fermentations (finishing at 1.026 or higher) with the dry extract in beers with an OG of 1.050+. That was with a full yeast starter & aeration. As a test I switched to the liquid and found fermentations routinely finish where they are supposed to.

And no clumping. :)

If you do stick with dme, I've had luck with a big sanitized whisk working quickly to dissolve the extract before much clumping could occur.

Cheers!
User avatar
Push Eject
Double IPA
Double IPA
 
Posts: 233
Joined: Wed Mar 21, 2001 1:01 pm
Location: Lancaster, CA, US

scoop it

Postby Okami » Mon Apr 09, 2001 10:06 pm

I use a 1/2 cup scoop to put DME in my brewpot.
After a few scoops it gets clumped on the scooper
and I just dunk it into the brewpot to disolve
it off. It takes a little longer to scoop 6+
pounds of DME this way, but I get it all in there.
Okami
Light Lager
Light Lager
 
Posts: 19
Joined: Wed Dec 27, 2000 11:47 pm


Return to Ingredients, Kits & Recipes

Who is online

Users browsing this forum: No registered users and 1 guest

cron