Sterilizing After Finding Mildew in Bottling Bucket

Brewing processes and methods. How to brew using extract, partial or all-grain. Tips and tricks.

Moderator: slothrob

Sterilizing After Finding Mildew in Bottling Bucket

Postby scorriga » Wed Aug 16, 2006 11:31 pm

I just pulled my bottling bucket out of storage, and it appears it still had some moisture in it when I put it away after the last use--I found some mildew growing in the bottom. I normally use an iodophor sanitizer, but figured I should mix up a bleach solution this time to ensure the mildew is killed off. I put in 1 tablespoon of bleach for 5 gallons of water and planned to let it sit for 24 hours. Does anyone have any input on whether or not this will do the trick?

On the one hand I don't want to throw out an otherwise perfectly good bucket out of paranoia, but on the other hand I don't want to risk contaminating the next batch of beer that I bottle.

Thanks,
Sean
scorriga
Light Lager
Light Lager
 
Posts: 21
Joined: Tue Jul 26, 2005 9:52 pm

Postby BillyBock » Sat Aug 19, 2006 1:01 am

The bleach should break it down, but I'm not sure of the contact time required. I think I would use some soap and a soft rag to wipe it out, rinse good, then follow it up with your bleach soak. Afterwards, rinse good again and it should be fine to sanitize at that point.
BillyBock
Moderator
Moderator
 
Posts: 561
Joined: Sun Dec 31, 2000 12:37 pm
Location: Ohio

I agree

Postby brewmeisterintng » Sat Aug 19, 2006 10:00 am

Give the bucket a good wash with warm soap and water insuring that you don't scratch the bucket, rinse in hot water and then use your bleach solution. Use cold water with the bleach with a contact time of approx 20 minutes and you should be back in business.

James
User avatar
brewmeisterintng
Strong Ale
Strong Ale
 
Posts: 382
Joined: Thu Jan 13, 2005 9:47 pm
Location: Clarksville, TN


Return to Techniques, Methods, Tips & How To

Who is online

Users browsing this forum: Bing [Bot] and 3 guests