Milling grains?

Brewing processes and methods. How to brew using extract, partial or all-grain. Tips and tricks.

Moderator: slothrob

Milling grains?

Postby Black_Raven » Wed Aug 01, 2001 10:44 am

Is it okay to use an electric coffee grinder to mill (or crack) the grains prior to mashing, or does this mill the grain to fine? I know I can mill the grains at the place where I purchased them, I was just wondering about alternative milling methods. Thanks, in advance, for any information regarding this subject matter... Jim
Black_Raven
 
Posts: 9
Joined: Tue May 29, 2001 11:04 am

MaltMill

Postby KBrau » Wed Aug 01, 2001 5:52 pm

I don't recommend using a coffee grinder as it will turn your grains into flour. This will cause your beer to be cloudy as well as making it nearly impossible to have an adequate filter bed for your sparge. The objective when milling grains is simply to crack the husk to expose its interior. If you are only milling small amounts (specialty grains for an extract batch) you can place the grain in a plastic bag and use a rolling pin to crack them, but for all grain batches I recommend buying a maltmill. I personally recommend the JSP Maltmill, but there are several on the market that do the job. If you can't fit it in the budget, most brewshops will mill your grain for around $.10 a lbs. Just be sure to mill your grain as close to your brewing time as possible for optimum freshness. I hope this was helpful.
User avatar
KBrau
Pale Ale
Pale Ale
 
Posts: 75
Joined: Wed Aug 01, 2001 9:13 pm
Location: Melville, NY

grinder

Postby puckerhuddle » Thu Aug 02, 2001 8:15 am

My brew-partner and I have successfully used a coffee grinder for small amounts of specialty grains (extract brewing). We have not had any problems with cloudiness. Just a couple short bursts will do the trick, and it's much fresher than milling at the store.
puckerhuddle
 
Posts: 1
Joined: Thu Aug 02, 2001 11:27 am

milling

Postby Mudbone » Mon Aug 20, 2001 9:19 am

What kind of off flavors can occur if you use a base malt that was crushed 6 or more months ago. I am adding 20% fresh specialty malts for additional flavor. Is this enough? I need to use up my old grain if possible.
Mudbone
 
Posts: 2
Joined: Fri May 04, 2001 2:52 pm


Return to Techniques, Methods, Tips & How To

Who is online

Users browsing this forum: No registered users and 4 guests