Analysis feature

General discussion on BeerTools Pro Software.

Analysis feature

Postby brocktonbrew » Fri Apr 25, 2008 5:10 pm

Question about the analysis feature in BeerTools Pro. I am having a problem getting the "WATER" in the session analysis feature to read anything other than 0.0 gallons. I have loaded a water profile and put in the correct volume of water on that page, as well as on the main session page, but the analysis section keeps showing 0.0...any suggestions?
brocktonbrew
 
Posts: 3
Joined: Fri Apr 25, 2008 4:50 pm

Postby ColoradoBrewer » Sat Apr 26, 2008 9:57 am

Have you set up a mash schedule? The volume of water under the Analysis tab is taken from that, I believe. Go to the drop down list (under the beer glass) and click on Session to set up a mash schedule. You should see the amount water needed under the Analysis tab.
BTP 2.0.8 (Linux)
User avatar
ColoradoBrewer
Strong Ale
Strong Ale
 
Posts: 263
Joined: Tue Oct 24, 2006 11:32 am
Location: South of Denver, North of the Springs


Return to BeerTools Pro General Topics

Who is online

Users browsing this forum: No registered users and 1 guest